[WANTED] small block pushrods for adj rockers & rocker saft hold down blocks

[DartmanTampabay]

I picked up some small block 1.5 roller rockers and need the following new or used

- SB pushrods for adj rockers (has cup end)
and
- aftermarket SB rocker shaft hole down set

Also looking for
- 1967-68-69 SB dipstick & tube

Located in St. Petersburg, FL - Greg

 

[1966Post]

Push rods for solid or hydraulic camshaft?

 

[mopowers]

What length do you need? Answering your ad is like shooting in the dark. Your rockers have cup-style adjusters - or you need push rods with cup-style adjusters? You have to be a little more clear on what you're looking for.

I have a set of RP-3107 push rods I'd sell you if they'll work.

 

[rumblefish360]

Tell us the length of the pushrod needed. I have a few sets.

 

[DartmanTampabay]

My apologies for the lack of information.

The 318 has 86-69 heads which were milled 0.020 and will have a CC XE268H cam with generic Summit hydraulic lifters.
Trying to take advantage of a set of Proform alum 1.5 roller rockers I picked up in a deal and was hoping to find a good set of 5/16 A-C cup pushrods.

My understanding is stock pushrod length is 7.33" and adjustable rockers with hydraulic lifters = 7.25" and I assume w/ the 0.020 head mill I would need in the range of 7.23" - can someone confirm?

It sounds like I should order push rod length checker.

 

[Demonracer]

You really need a push rod length checker & then get with 3B for optimum rocker arm geometry.