[FOR SALE] Tail of 3 Dominators ( L 9375)

-
Status
Not open for further replies.

GTX JOHN

FABO Gold Member
FABO Gold Member
Joined
Dec 12, 2009
Messages
2,778
Reaction score
3,412
Location
Boulder City NV.
Rating - 100%
68   0   0
Contact seller
Holley Dominator
New in Box and still in Plastic Wrapper
It was bolted on a Display Engine for Sema show
but appears to never been run
List L 9375
3 Circuit
1050 CFM
Soft Progressive Linkage
These 3 are the most Desirable 3 Circuit Dominator
that runs the cleanest and easiest to Tune = According
to all the Top Carb Tuners and Modifiers
I got this with a Drag Car I purchased.
I never used it as I already owned several of these L9375
that were working perfect!
$675.00 ( $1,150.00 new if you every find one)

I have another L 9375 Dominator with four Dyno Pulls
and a few trips to the Strip.
$495.00

I have another L9375 That has several years of use on my
Street Outlaw style Racecar that got to Final in "Pinks All Out"
on TV. It has had more use but the Throttle Shafts are still very
tight and all surfaces Flat.
$425.00

These were hands down the best combos on my Race Cars but I
have Sold both my fast race cars as I am getting too Old and can
not get Licensed to go faster than 10 Seconds anymore.
The new HP Dominators are impossible for me to get to run
right other than at Full throttle and are murder on the plugs.

Racer7411@yahoo.com

d.jpg


d2.jpg


d3.jpg


d4.jpg


d5.jpg


d6.jpg


d7.jpg


d8.jpg


d9.jpg
 
Last edited:
I have run almost every style and model of Dominator over the
last 20 years for a Single Carb application these are Absolutely the best
one ever produced and hard to find! The HP Series have proved to be
much more problematic to ever get to work correctly.
 
$425 and $695 are still available
$495 is sold and delivered

I am a bit flexible on the prices at this point

I just found a King Demon that looks like new that
I will advertise next week or two.
 
Bump!

I just found a NEW King Demon Annular 1090
Drag Race still in the box with all the paperwork and
instruction complete. I do not remember if I ever used
it for any Dyno pulls or not.

$695.00

I will pay all shipping on my dime on any of these.
 
Status
Not open for further replies.
-
Back
Top