[SOLD] Upper Control Arm Bushing Reinforcement Rings On The Rear Bushings.

-
Status
Not open for further replies.

hemi71x

FABO Gold Member
FABO Gold Member
Joined
Dec 22, 2009
Messages
7,617
Reaction score
4,850
Location
Rancho Cordova, CA
Rating - 100%
73   0   1
Contact seller
Lots of members continually ask me if i have more of these reinforcement rings, that were used on the rear UCA bushings, on some of the Mopar automobiles in the later 60's into the 70's

I don't think they did any good, but some brainy suspension designer, engineer, back in the day, with Ma Mopar, thought they did some good, for what reason or another.

As you can see, i took lot's of UCA's out of cars to rebuild, recondition, back when they were find able, at the Pick-N-Pull wrecking yards.

I used to remove the shot bushings, and ball joints, and sell the UCA's to my buyers, so that's why i have lots of these rings.

Supposedly
6 cylinder taxi cabs got them, and a "high performance" car.
But what determined a high performance car, anyway, getting these things in the first place?
Then why didn't every car with a 340, 383, 440, get these things. Dunno.

Probably what was just on the suspension building assembly line at the time.

Anyway, they have been leaving my hands at $20.00 a pair, so i will continue selling them at that cost.

Plus the mailman, what i can figure out the best to your zip code.
Payment will be thru Pay Pal
Jim V.
hemi71x



UCA Rear Bushings 011 (Copy).JPG


UCA Rear Bushings 012 (Copy).JPG
 
Last edited:
Status
Not open for further replies.
-
Back
Top