upper control arm rear bushing

-

Bud27

Well-Known Member
Joined
Dec 26, 2014
Messages
156
Reaction score
10
Location
West LA
Doe's it have a spacer ? I took off the pasenger side control arm because the bushings are bad . The front bushing no problem ball joint was tough but no cus words . The front bushing was hell after beating the crap out of it with air chisel finally got it out ,but there's what looks like a spacer on it . How is that put back on just press it on to the bushing I'm using moog replacements on 65 Barracuda.Any tips would be super helpful.
Thanks in advance
 
I used the MOOG offset bushings. They came with 4 washers per side (2 big ones, 2 smaller ones). The washers had about 1/4" of 'shaft' to one side. The 'shaft' was just a touch to big to fit inside the bushing. I touched them to the grinder to slightly bevel the edge of the 'shaft' so it would start into the bushing. Then I stuck them in the vise and pressed them into the bushing. Hope this helps.
 
-
Back
Top