What's missing on this linkage?

Discussion in 'Fuel and Air Systems' started by Troub, Sep 9, 2018.

  1. Troub

    Troub 67 Dart 270, 225 slant six

    Messages:
    103
    Likes Received:
    19
    Joined:
    Jul 25, 2018
    Location:
    Florida
    Local Time:
    5:42 PM
    As I was pulling the starter today it got tangled up in the throttle linkage and popped some bits off. Does someone have a pic of the clip that goes on the grooved piece to the left of the nut in the pic? Something goes there to hold the arm in place. I think the spring (it broke) attached to the groove at the end. Need a pic of what does in the inner groove next to the arm.
    Help is appreciated. Seems every time I fix something in this engine bay something else breaks!

    IMG_1532.JPG

    IMG_1531.JPG
     
  2. xLURKxDOGx

    xLURKxDOGx "An angel fat, at satan's feast"

    Messages:
    2,350
    Likes Received:
    438
    Joined:
    Dec 27, 2013
    Location:
    PHX
    Local Time:
    3:42 PM
    I’m pretty sure it’s a washer and a clip.

    Jake
     
    • Thanks! Thanks! x 1
    • Agree Agree x 1
    • Mattax

      Mattax Just the facts, ma'am FABO Gold Member

      Messages:
      3,747
      Likes Received:
      1799
      Joined:
      Feb 7, 2013
      Location:
      Phila. Pa
      Local Time:
      6:42 PM
      Yes. hairpin style spring clip and a washer keeps the slider in place.
      Spring goes over the outer groove.
      Should be a good picture in the FSM - look in the Fuel Section for throttle linkage diagrams.
      Another place that I *think* has good illustrations is in the MTSCs that review A/T transmission throttle linkage adjustment/
      Go to www.imperialclub.org -> repair Lit -> Master Technicians Service Conf,
      1971
       
      • Thanks! Thanks! x 1
      • Troub

        Troub 67 Dart 270, 225 slant six

        Messages:
        103
        Likes Received:
        19
        Joined:
        Jul 25, 2018
        Location:
        Florida
        Local Time:
        5:42 PM
        Thanks guys! Much appreciated.
         
        Last edited: Sep 11, 2018