daddio4048
Daddios72
Having to change out front floor pans & ordered some off Ebay & they were terrible;not even close. I know AMD makes whole side floor pans;but I don't need the whole side. Are the Sherman pans any good ?
Who has the best floor pans available ?
- Thread starter daddio4048
- Start date
-
What do you need?
Most of the stamped stuff is marginal at best for portions of a floor pan, as you've found out.
Most of the stamped stuff is marginal at best for portions of a floor pan, as you've found out.
daddio4048
Daddios72
I'm needing both drivers & passenger side front floor pans.
SLOPAR72
Well-Known Member
I got one off Ebay for a partial PS front floor. Not great but I figure who ever ends up with the car when I get bored will replace the whole front floor pan lol.... I did because with enough welding and grinding I could hide it pretty good. However if I was serious about doing it right it would be AMD no questions asked....
JW
moparmat2000
Well-Known Member
AMD
daddio4048
Daddios72
Just wanted to update on what I found to be the best front floor pans I found. Ordered a drivers side pan off Ebay & found this pan to be as close to factory stamping as I have seen. Took piece I had cut out & placed over new pan & it fit very well. The link to these pans is below.
Chrysler A Body Left Front Driver Floor Pan 1967-1976 Made in USA | eBay
Chrysler A Body Left Front Driver Floor Pan 1967-1976 Made in USA | eBay
famous bob
mopar misfit
those are the ones I put in my 68 barracuda. still had to massage them a bit.
-
