Grampas Toy
Well-Known Member
Here are the pictures that go to the first post.
#1 4" V.W.on the left mopar 5-1/2" right
#2 same
#3 same
#4 after plasma cut grind even ( only rears)
#5 check edges w/ feeler gauge,,grind down high spots
#6 same as #5
#7 Cut just behind the weld,,don`t try to cut weld.(it`s too deep)
#8 Ripples from rolling,,smooth out
#9 Measure (ears) make them the same.
#10 When your close,,mark edges w/marker roll around on table exposing high spots (all edges)
#1 4" V.W.on the left mopar 5-1/2" right
#2 same
#3 same
#4 after plasma cut grind even ( only rears)
#5 check edges w/ feeler gauge,,grind down high spots
#6 same as #5
#7 Cut just behind the weld,,don`t try to cut weld.(it`s too deep)
#8 Ripples from rolling,,smooth out
#9 Measure (ears) make them the same.
#10 When your close,,mark edges w/marker roll around on table exposing high spots (all edges)
