New articles

pishta
1 min read
Views
115
Reaction score
2
The infamous clack clack clack of the blend door actuators on newer Chrysler products. Took the rear one apart and found the failure point. The white gear shaft sheared off the base of the actuator causing the gear to move off the teeth and make the clacking noise. FiX: Drill out the center of...
halifaxhops
1 min read
Views
261
Reaction score
1
OK where do I start. There is a ton of mis leading information about adjustable Vacuum advances out there. None of the mopar NOS or aftermarket are adjutable for the amount of advance, just the rate of advanc. Yes you can limit them with wire etc, but they are just adjustable by the rate of...
ray morrow
1 min read
Views
232
i ,am building a stroked 440 rb motor i,am using trick flow heads 240,s aluminum. with a comp roller extreme cam . the roller rockers are from trick flow, i think howard makes them, thats what i hear. the rocker assembly is comp cam rollers . can any body know what length push rods to use ...
Top