Recent content by 71dustar

I am selling the Plymouth Duster and have dropped the price since early 2017. The car is on eBay (1971 Plymouth Duster | eBay). The photos are high quality and can be seen on eBay. I'm trying to sell the car before the end of the year so the price is negotiable. Asking Price: $25,000...

Video of vehicle driving by.

When shifting from 2nd to 1st gear, the transmission will free spin (engine will drop in rams to idle) and is advisable to only shift into 1st at low speeds close to a complete stop. As mentioned above, when shifting from 3rd to 2nd the engine will increase in rpm accordingly. The manual valve...

I will sometimes go to the McDonald's Pavilion Car Show on Saturday nights.

The seats are Sparco Milano 2. The photo of the 3/4 rear shows one of the reverse lens out, yet both are installed currently.

1971 Plymouth Duster 4,512 miles Fountain Hills, AZ Price: $35,000 (cash) Time to sell the Duster so I can invest the capital in my engineering business. I bought the car in November 2007 from the original owner (55,*** miles) who bought the car new in Arizona. Only rust was in the typical...

So I have been contemplating building an aluminum intake shroud to seal the 6 pack hood of my duster to the carb. Here in arizona the ambient air temperature is still considerably hot but will of course be a considerable amount cooler than the engine bay ambient air temperature. I have a few...

I would like to know the part number or place to buy just the ball angular style bearings that locate and retain the worm gear shaft. Thank you.

I tore apart my steering box to replace the worm gear (20:1 now) and also the pitman arm. With everything mounted in the car, I have a considerable amount of dead space in the steering wheel. This is due to the mesh between the pitman arm shaft gear and the worm gear. Is the pitman arm shaft...

I disassembled my steering box to install a new worm gear but have misplaced the one component that attaches to the pitman arm shaft and can be preloaded via a screw on top. Does anyone have a picture of this part or know where to obtain another one? Ciao, Jon

I recently heard through the grape vine that if I were to machine my dual plenum intake a 1/4" down on the bridge (to allow equalization between the two) there could be some HP gains. Has anyone experimented with this modification created by Smokey Yunick (I believe credit goes to him or at...

Will the rallye style wheels 15x7" with +6mm offset fit up front on a 1971 duster with wilwood disc conversion and BFG 215/60/15 tires? (http://www.summitracing.com/parts/WVI-56-5712044/)

I'm looking for another set of wheels for the duster but more for cruising since a friend and I may be planning a 700 mile road trip around AZ. Instead of going with aftermarket, I'd like to go after some rally style wheel but not sure which would be best: 14" or 15". Is there a noticeable...

will 950cfm be over doing it?

Could not find exactly what both have said so is the following link what you meant? http://www.summitracing.com/parts/HLY-0-80496-1/