I'm installing a new electronic ignition engine wiring harness in my 69 roadruuner. I would also like to install a new solid state voltage regulator made be Regitar Model:C524 I have a new Mopar ignition module and have everything wired up (i think) but need some input on how and if I can...
I just bought a 26" Champion Aluminum Radiator model# CC374, for my 1989 360 engine in a 1969 B-Body. Does anyone know if there's a mopar shroud that will fit or can be modified to fit the 4 bolt pattern on this model. Please advise, thanks.
Can someone tell me the length of the metal bushing/spacer for the power steering pump mounting bracket? It's a 1989 360 engine, I can't find the original but will have to make one. Take a look and let me know, thanks.
I just upgraded my 318 engine to an MRL 408 Stroker, in my 1969 Satellite. I'm having a problem installing the power steering pump as the water pump on the other engine had an ear on it to attach the power steering pump bracket. The new water pump dumps to the other side and that's the only...
Looking for a two grove crankshaft pulley for a LA360 small block. This is the one that bolts on the damper. Let me know if you have one for sale or trade, thanks.
Can anyone tell me if there's a place where I can find a header stud kit for Small Block Edlebrock Heads with 5/16ths exhaust port threads? ARP only has 3/8th's studs and I can't seem to find these anywhere. Let me know thanks!!
Drive Shaft-- used for one season, last year replaced u-joints, balanced and powder coated at shop. Length is 55.5 inches from middle of u-joints front to back, length of shaft is approximately 52 inches. This also comes with differential yoke and 904 transmission slip yoke, see photos. This was...
Just completed front disk brake upgrade along with new master cylinder and power booster, rear brakes are drum. I have a clean system what brake fluid would be best, let me know your thoughts. Thanks
Looking for a recommendation for a set of studs to mount the headers on my edelbrock small block heads, also what's the best header gasket. Want to make sure I get the best so I don't have problems later. Also, are the end holes water jacket like the iron heads? Any mounting info or experience...
I'm looking for a bushing for my power brake linkage, the small one on the right. Anyone know where I might find this? I was told the part number is 2534346, but have had no luck finding one. Thanks