Recent content by jawbone

That's an under statement.

I won't disagree with you. I wanted to keep my old style tapered bearing setup. Was lead down the garden path by Moser to use green bearings. The axles I provided could not be shortened and re-splined. If I have a hint of something going wrong, it's $500 for another set of axles that will...

I have cone style sure grip. Green bearings are fixed thus if axle too long, will hit thrust spacer. Only way to get it out, that I know of, is to disassemble SG. Don't want to find out after everything installed.

Good reading. How I Do It, Sure Grip Spacer Pin

What I see does not look like that. To remove pin, does that require disassembly of sure grip?

Interesting to here and sorry it happened. I cannot draw mine out even with a very strong magnet. Was yours a cone sure grip, disk or open style?

The axle diameter was ginormous.

Thanks for your suggestion.

Hi Jason, Well that was unexpected. Will axles go in without interfering? Just to let you know the axles I got from you; Moser could not use them. No biggie.

Hi FABO. It's me again. Engine is in. Working on replacement of 7 1/4 with 8 3/4. Have a narrowed housing and axles with green bearings from Moser engineering. Comments came up regarding thrust button or thrust block removal. Research tells me the cone style sure grip, which I have, does...

Think there common to the later style.

These are backing plates with wheel cylinder piston stops.

Hi S'cuder. Thanks for the notification. Was wanting plates with wheel cylinder piston stop if possible. Will keep looking for now. Quite possible may accept what I can get. Thanks again.

Hey Dew. See what you have and post how much. Thanks.

Thanks for the response. Do you have the shoe spreader bar and e brake bar as well?