Recent content by jhnycuda

2nd in line if that falls through.

I have a drivers door with glass from a Valiant up here in Lancaster, Ca.

The cam card will tell ya where they suggest, the 408 in my Valiant are at .020, been about 5 years, no problem, RHS iron heads.

Have a 742 case pumpkin, new 4.56 gears, 35 spline Moser spool, a pair of 742 yokes, 1 is a 10 spline, the other is a 29 spline, both use the 7260 u-joint, a new 489 yoke, 29 spline, uses the 7290 u-joint, a set of rear bumper brackets for a '70-'71 Barracuda/Cuda, (may fit '72-'74?). $700 for...

Doing a little cleaning, have a clutch fork (I think early A-body), along with pivot ball brackets and linkage, $50 shipped to the lower 48 for all of it.

I have a Addco front sway bar, not sure I have the brackets for the K-member, can look later after work, can have it for $100, I am starting to clean out my garage and shed to move next year out of state, I am in Lancaster, Ca.

Hey guys, got one from a member, thanks!

:lol:

I have one in Lancaster, $200?

Hey guys, looking for a headlight switch plug/connector for a '66 Barracuda, (I would imagine the other early A-bodies are the same), the one that Amazon and Standard show does not fit, if anybody has a parts car or extra harness lying around, would like to buy the plug with maybe 6" of the...

Do you have a good set of rockers from it?, (Comp, Harland etc)

I have a 904 here in Lancaster, I honestly don't know it's condition, bought it as a core, was supposedly from a running car. PM me if interested.

Dang, that was quick, guess I can be third.

Hey guys, looking for a 727 10" convertor, around 3000 stall, would prefer the 7/16" bolts instead of the 5/16" bolts. I am in Lancaster, Ca.

I have a set of like 10 or so 340 rods that I have no use for, you can have all of them for $75 shipped, I am looking at moving and am cleaning my cabinets and shelves some, they have no pistons on them.