Recent content by THWrench

  1. T

    Dog dish hubcaps wanted

    Sorry, the ones I have are different.
  2. T

    Dog dish hubcaps wanted

    I may have what you are looking for. I will check tomorrow and let you know.
  3. T

    Car show pic's

    Did you by chance get any pics of the Dart that they a raffling off? I didn't have my camera today and missed getting some good pics of some nice looking cars
  4. T

    1971 Dart Swinger For Sale

    I am selling my 1971 Swinger a very nice driver, it is glacier blue with a white vinyl top. The numbers matching 318 engine and 904 transmission have both been rebuilt less than 3500 miles ago. At that time the radiator was rebuilt with a three row core. The heater core, water pump, fuel pump...
  5. T

    Ford question don't shoot

    Some Fords have an electronic flasher that is used for both the turn signals and the 4 ways. The ones that I have replaced are blue in color and can be found on a bracket that is under the dash just to the left of center. There is another componet on the bracket as well whitch I think is the...
  6. T

    I need trim clips !!

    Thanks fellas for the links to the restoration places. I checked their catalogs and found clips for 67's and 69's but no 68. I have asked at the shows and e-mailed RTS and nothing. I am almost convinced they are not available from the repop market. Thanks Again!
  7. T

    I need trim clips !!

    I have a 68 Dart 270 and need the clips / fasteners for both rear quarter trim pieces. I haven't been able to find any at the bone yard. Everyone removes the trim and fills the holes. If anyone knows of new parts that would even be better. RTI does not have these parts. I have seen them for a 69...
  8. T

    Radiator overflow

    Check your cap!
  9. T

    Setting Idle speed / Stallingin gear

    If you have power brakes you might have a bad vacuum booster. Set your parking brake and disconnect and plug the vacuum hose from the intake to the booster. Then put it in gear and see if it will idle.
  10. T

    8 3/4 swap

    Thanks for the info guys. I am not much of a fabricator so I will try and find a pair.
  11. T

    8 3/4 swap

    I am installing an 8 3/4 rear axle in place of the stock 7 1/4. My question is can I use the original shock / mount plate? The third member is the 489 case with 383 gear set. I will be installing a lunch box locker from Power Trax, any feedback on the locker?? I will be running about 325 hp.
Back
Top