I'm thinking of using the steering column from the donor so I have cruise control etc. I think this would also tie in the gear selector to the display.
Any thoughts?
I have just started a 5.7 hemi swap into a '68 2wd Suburban (partially for the power, partially to piss off the Chevy guys). I have a complete 2005 half ton Dodge pickup donor. I plan to use the complete motor/trans (auto), along with the stock gauges from the Dodge.
I know there are a lot of...
Thanks for the reply, I think the website that had the MP flywheel weight listed at 18.5 lbs may have been incorrect, can anyone verify the correct weight on this one?
I am getting to order a flywheel for my slightly modified 360 Magnum that will be going in my Demon.
Looks like the choices are the Mopar P5249842 and the Mcleod 464102-15A. The main difference I see is the MP flywheel weighs 18.5 lbs and the Mcleod 30 lbs.
Any suggestions? Car will have some...
Does anyone know the difference between the Mopar P4529110 (360 LA) and P5249842 (360 Magnum) flywheels?
Both are 130 tooth, 10.5" clutch, 6 bolt attachment to crank.
Any thoughts?
I have a Dart/Demon dual snorkel hood scoop, I am missing the lower front part of the snorkels. Please message me if you have one or might know where one is.
Thanks!
Looking at getting a new set of headers for my small block 4 speed Demon.
Do all brands require that the steering be disassembled to install the drivers side header? The headers that came with the car are this way.
Thanks in advance!
I found a new in the crate 360 Magnum engine and I am thinking of putting it in my 4 speed Demon.
I did a little research on what needs to be done to install it in place of a standard small block.
Are there and cheap mods that can be made to it to bump up the performance? Was told that shaving...