What intake bolts for Magnum heads and M1 Magnum intake
- Thread starter KevinB
- Start date
-
xLURKxDOGx
"An angel fat, at satan's feast"
I bought it from the link below, and I bought the only one they had left. I believe it's discontinued
Aluminum Dual Plane Intake 4-bbl Carb [P5007381ab] - $344.85 : CHICAGO CONNECTION, Your High Performance Parts & Accessory Shop
TrailBeast
AKA Mopars4us on Youtube
13 bucks or so from Summit.
You probably couldn't get them all with washers from a hardware store for that.
https://www.summitracing.com/search...2l-318/engine-family/mopar-small-block-magnum
You probably couldn't get them all with washers from a hardware store for that.
https://www.summitracing.com/search...2l-318/engine-family/mopar-small-block-magnum
I bought mine from McMaster-Carr.
I just bought stainless bolts and washers.
I can measure one of them tomorrow.
Congrats on getting the intake, I bought the second one they had left.
I just bought stainless bolts and washers.
I can measure one of them tomorrow.
Congrats on getting the intake, I bought the second one they had left.
They are pretty nice, it makes good power right from idle.
It does take a small thermostat.
It does take a small thermostat.
Also, I drilled and tapped the center 1/8 NPT temp sensor hole to 3/8 npt to run a mechanical gauge. Along with the stock gauge. I think this was on over site by mopar.
skizzo
Fubar Emeritus II
3/8" x1 1/4" socket heads are nice for access. I just used my old LA arp's.
If you have a TCS near you you can get grade 5's pert cheap by the lb.
If you have a TCS near you you can get grade 5's pert cheap by the lb.
What heads are you running?
I have eldebrocks on mine and the bolt size is 5/16-18 x 2"
I have eldebrocks on mine and the bolt size is 5/16-18 x 2"
-
