Search results for query: *

Do all LD340 intakes have a factory part number? I am surprised to see a Chrysler p/n on an aluminum 4bbl intake!

I have a 1966 3.09 low gear trans that I converted to a long tailshaft for my Bbody race car years ago. At the time, all I had to do was to put all the gears, synchros and sliders from the 3.09 trans onto the long tail shaft and bolt the long tail shaft onto the 1966 3.09 front case. Can I...

I would appreciate it if someone could tell me what the fasteners are for bolting the rear bumper bracket to the body on my Barracuda? My bolts are 7/16" dia. x 1 7/8" long with about a 1" shoulder before you get to the threads. They have a heavy washer and a retainer clip holding the bolts onto...

FOUND-Looking for new brackets or a nice original set that are not pitted...my old ones look like you know what on my new springs! Call John 703-608-0977

Does anyone know if there are repro front spring hangers available and where to get them? Mine are very pitted and look worn on the inside where the front spring seemed to be rubbing against the inside. I know the B and E body spring hangers are available but can't find ones for my 69 Barracuda?

Anybody here using a MR. Sixpack (Bob K) cam in their 340? What kind of vacuum are you getting with it? I'd like to use it but I have A/C to worry about.

What are the correct OE fastener nuts for mounting the trim panel? How are the holes sealed where the trim panel mounts to the deck lid?

Anyone know where I can get rocker molding clips? R/T Specialties and Restoration Specialties are no help. Good used ones would be fine. They are plastic (nylon) 1 5/8" high x 1" wide with a number 6002840 on themI also need a nice A/C condensor for up front. Mine is toast! Any suggestions will...

I'm restoring a 69 340S Fastback 4 speed with A/C back to OE except for a little cam, LD340 intake and some Cragers. It's B5 with black deluxe interior and no console, 3.23 sg, ps, pdb, am radio, rocker moldings and no strips or pinstripes. It's painted and I am in the process of putting it...