Search results for query: *

Thanks. I'll check YearOne online.

Hello, Anyone know the factory part numbers for the exterior 1967 Barracuda Door Handles? I can find up to 1966 and then 1968 and up but not 1967. Also, any suggestions as to a source for purchase? Prefer NOS or good quality repro. Thanks

Try www.freemansauto.com in Whitehall Montana. It's not exclusively MOPAR but has a large area of MOPAR-only cars and parts.

I'm looking for a good-condition PS non-column shift steering column that is correct for the 1967 Barracuda. This is a new project of ours; building a '67 Coupe. I've read multiple posts that state that other years/models columns will "fit" the 1967. That's not all I'm trying to determine. I...

If you are still working on the PS question...I had my PS box rebuilt last year by FFI FirmFeel, in Vancouver, Washington state. They offer three levels of firmness; all of which are "police" spec or higher. I took the lowest and it's perfect for me. They also rebuilt my PS pump. It's in my...

I recently purchased a new plastic/chrome knob for my 67 Barracuda AT. It was perfect quality item! Source was B/E&A Restoration Parts Inc. www.BEAparts.com or 330-725-3990. Check out any issue of Mopar Collector's Guide; lots of listings for dealers, restoration companys, used/NOS parts...

Question about source for gaskets for '67 Barracuda back-up lights; one source that I've used is www.laysons.com. In Tacoma, Washington. They also have rep bezels (excellent) and lenses. There are other sources too; look in Mopar Collector's Guide.

Hello, Thanks for the replies. We found the problem; intake manifold bolts were not torqued. Redid them and no leak! The suggestion to retorque the intake AFTER the two 20-minute initial break-in runs was part of the written instructions from the machine shop (I didn't READ everything...

Don, I have a set of four 14x5.5 (could be a bit wider but the tires are still on them so I'm not certain). These have a circle of drilled holes; not slotted as you listed (thouht I'd ofer just in case). I use one of the wheels as my Avatar. I can send photos of the other three. I wish to...

Hello to all. I'm writing to ask advice about a (likely) vacuum leak. I have a '67 Barracuda Convertible with a recently-rebuilt 273-4 Hi-Po (not by me; a local machine shop), .030 over; Hughes did the heads (ported and "larger" SS valves). Compression is estimated at 9.2. Cam was size...

Thanks for the comments about the "interchange" manual; particular the EX WIRE individual on E-Bay. I'll check it out!. :)

Hello, I was searching for the correct 1967 Barracuda-only bucket seat headrests for my Convertible. One of the "100 million" locations (!) was for this Web site. No one had headrests for my car; lots of "A" body headrests, however. :)

Dave, Thanks for the info, but I'm looking for part number compatibility; particularly as it applies to headrests. The 67 Barracuda had one-of headrests (as far as I can tell). It's likely I must find one of those headrests. However, of equal importance is to get the hardware (clips, face...

Anyone know of a source for a parts interchange "manual" or document that includes the 1967 Barracuda? I've found only the 68-74 Manual. I'm hoping that not everything on the '67 is a "one-of"! Thanks.