Search results for query: *

  1. 73318duster

    Electrical Problems

    had a shop do some work on my quarter and rocker panels. while the car was there i asked if they would be able to replace the turn signal assembly which they did. When I went to pick up the car, the tail lamps would not turn on. I was told it was probably some loose ground. Left the car and...
  2. 73318duster

    Non Mopar car issues

    So my commuter is a 2008 civic. I noticed that the heater would take a bit to get hot. I checked the coolant and noticed added some. About a week later I decided to check again, and it needed more coolant. I took the car in to my mechanic and he did an oil change and could not see coolant in the...
  3. 73318duster

    Eastwood RatRod Satin

    The body work on the duster is almost done, windows are all off and new rubber is getting put in. I dont have the money to pay for a 2 stage paint job and was kicking around the idea of getting some Eastwood Rat Rod Satin http://www.eastwood.com/review/product/list/id/2832/?p=1 Has anyone...
  4. 73318duster

    Need some help with some wiring

    I am in the process of putting everything back on the intake manifold but for some reason I cant figure out where the connect these cables. Any help would be appreciated. :oops:
  5. 73318duster

    Bolt Size for Water Neck and Ignition Coil

    I replaced my stock 2bbl carb and intake with a Edelbrock 3776 Intake Manifold and Edelbrock 1405 4bbl carb(pending installation). For some reason the bolts for the water neck and ignition coil do not fit this manifold (3776). I tried them on the old manifold and they go all the way down. I took...
  6. 73318duster

    Intake Manifold Removal

    I am removing the 2bbl card and intake manifold off my 318. Does anyone have any tips/suggestions as to how to remove it? Should I just use a pry bar and try prying it from the front? :burnout:
  7. 73318duster

    Wanted - Door Panels for 1973 Duster

    I am looking for some door panels for my 73 Duster. Need both Driver Side and Passenger Side front panels. Color doesnt matter as long as they are in good condition.
  8. 73318duster

    Intake Manifold Gasket ?

    I recently purchased a Edelbrock 3776 Intake Manifold to install on my 318. I went to the local performance shop and was told to buy the Edelbrock gasket and use RVT sealant, not to use the FelPro Gasket because it tends to break apart. My friend who has a 73 Satellite with a 318 installed a...
  9. 73318duster

    Ignition Module Question

    Long story short, I bought this 73 Duster w/ a 318. After sitting for 2+ months due to complete roof replacement ect, I tried to start it up. The wife's nephew who claims to have worked at a shop before put the battery on backwards. Some smoke came out of two separate wires so i took the cables...
Back
Top