Search results for query: *

That's what I need. Thanks I might take u up on the the piece of crossmember. I'd rather use the right piece than try to make up something.

I need the 69 measurements. The ones I need the most is the measurement between the trans x-member bolt holes on the driver's side and between the inner bolt holes. I have a small section of the brace missing from my car, where someone cut out the tunnel for a 4-speed. I wanna try to graft in...

Can anyone give me the measurements for the v8 tranny crossmember? I need the overall length, and the measurements of the mounting holes on both sides. I have a 63-66 torsion x-member and I wanna try to graft it in to the piece missing in my 69.

I just sold one, 8-3/4, with axles, 489 case with a 3.23 Sure Grip for $600, to a board member. Now the B-body axle I have, I couldn't give away.

Thanks

I was thinking maybe $300 for the housings and $350 for the center.

Anyone know what the going rate is for a good 8-3/4 rear housing is? I want to sell a few locally but don't know what to ask. They are good housings, with axles, one for the A body, one for the B body, no center section. A little greasy but otherwise in good shape. I do have a center section...

It's a Sure Grip axle. It was just barely 5 revs, maybe a shade less. That's why I guessed 4.88.

My buddy said I had 4.10's in the rear of my Barracuda. I just got it up on stands today, and turned the pinion to check. It spun 5 revs for 1 rev of the tire, and its a big tire (275/60B14). I'm guessing 4.88's. Might just have to pull the center section and verify.