Search results for query: *

I'm installing a new electronic ignition engine wiring harness in my 69 roadruuner. I would also like to install a new solid state voltage regulator made be Regitar Model:C524 I have a new Mopar ignition module and have everything wired up (i think) but need some input on how and if I can...

Anyone have a photo of how the switch should be greased?

Put metal washer on unused FLD terminal and everything's good, thanks!

Been away from this for a few days but I think you guys are on to my problem. The VR is a solid state version of the 1969 model so it's new but looks original. The alternator was in the car when I got it but after some research it seems to be an after 69 model as it has two FLD terminals and...

Voltage regulator new from Regitar solid state chrysler c524, wiring harness new from year One HU181B 1969 B Body 318, new HEI procomp electronic 2-wire distributor.

Please see photo and check the blue wire that is on the same connector with the brown wire that feeds one side of ballast resistor. The blue wire has a round connector with a "D" shaped opening. It look like it should go to the (+) side of the coil. Is it even used, maybe my new wiring harness...

Just installed a new HEI procomp distributor on my 1969 318. Also installed new engine wiring harness, removed ballast resisitor (jumpered connections together) and replaced voltage regulator with new electronic regulator, that looks stock. Started right up on first try and everything looked...

Checked FLD connectivity from regulator to the FLD on the alternator and its good. Is there a way to see if regulator is bad, it's not shorted but not sure what I should see across the IGN and FLD tabs.

Just installed a new HEI procomp distributor on my 1969 318. Also installed new engine wiring harness, removed ballast resisitor (jumpered connections together) and replaced voltage regulator with new electronic regulator, that looks stock. Started right up on first try and everything looked...

Can I connect my edelbrock 600 electric choke positive to the coil? Has anyone done this or will it cause any issues? Trying to clean up wiring and looking for the easiest way, any thougts on this? Thanks

Is there a way to wire an after water market temp sensor but also keep the gauge cluster temp sensor functioning? Has anyone done this, let me know. Thanks

Yeah, guess I'll just move the #1 plug over a couple spots, shouldn't be a problem as long as #1 fires at TDC. I was preparing to send it back but I guess they're all like that, I'm still going to call the guy to see what he says. thanks

I was looking at the new distributor next to my old one and noticed that it lines up different. Please see photo, the original has the rotor parallel to the key that goes to the oil pump gear (they both point in the same direction). The new one is off by at least an inch as the rotor is off by...