Search results for query: *

My last 904 pan gasket leaked all the time.....constant dripping from the edges. Reseal it 2 times, same result. Now I installed a newly rebuilt 904. I figured that the tech installed the pan gasket, so all should be good. Installed it, and yup, it leaks around the edges of the pan :( So...

I’m starting with a rebuilt 904 Tran and new torque converter. 1). Before install, any prep like filling TC before install? 2). Take me through the process: filling the transmission , First start up and drive Thanks

Looking to get a 40T speedo gear for a 904. Ebay has LA speedometer gear for Jeep.; Dodge Jeep 40 Tooth Speedometer Gear Long Shaft | eBay will that work? are the gears and shaft the same? I'm going with a late 60s 904 trans

I'm installing a 1984 318 with lock-up 904 into a 65 Barracuda. I bought the "special" speedo cable, that fits the lever shift 904 trans TO the 65 speedometer. All should have been right in the world. but its not. It turns out that the "special" cable is for the aluminum thread on cable...

for a 904, I have a few old driveshafts kicking around. I noticed that there are some long and short ones. (no measurements on hand). What gives? I would have thought all the 904 slips would be the same. can someone tell me when they would used 1 vs. the other?

On a 1965, I'm going from the single pin NSS (neutral safety switch) to a later trans with the 3 pin NSS. Once I find a 3 pin pigtail....what should my wiring mod be? I want to keep the NSS function. thanks.

76 Dart, 3 on the tree. shifter works fine in the up and down throws. Pulling in the center of the 'H"l...very stiff. especially cold. spring return to the 2-3 slot seems to work. Question: how do I lubricate or/and adjust the resistance of the column shifter lever? car is full...

What is the part number and a vendor for the small snout TC to large crank bore adapter ring? (putting a later 318 against and early A trans with the small snout TC) Thanks Mike

Stock configuration: 1973 Dart Sport. 340/727/8.25. what is the driveshaft length C to C AND what is the slip yoke length? Question 2: 65 Dart. SB/904/8.75. driveshaft length?? thanks

Since I dont' have the car assembled yet, I can't measure what I need; so... Anyone know the proper driveshaft length for a 73 Dart Sport, V8/727 - 8.25 rear?? Thanks.... Mike

73 Dart Sport. was a 318/904/7.25. It will be a 72 340/727 with a choice of rears: A) 8.25 SG w/3.55 gears (cone style) B) 8.75 SG w/3.55 gears (741 case, clutch style) C) 8.75 SG w/3.23 gears (489 case, cone style) #1 Which rear would you pick and why? #2 What stall converter...