1968 Barracuda trim removal help please!

[AHcuda]

Anyone know how these pieces of stainless trim are held in place? or how you remove them?

 

[LS-300]

Bolted in from below the trim

 

[BIG-B-Barracuda]

they are not bolted, they are clipped from the inside.

mine are anyways.

"1968 barracuda notch"

 

[rednesss]

The trim along the top of the door, is just held on by about 6 or 7 metal clips, gently pry up on the moulding from underneath using a plastic glass installation tool, or some other plastic wedge shaped trim removal tool.

The trim on the quarter glass has 2 metal clips on the horizontal section, but is held in place in the upper vertical section by 2 screws that need to be taken out from behind the rubber window seals to the glass.

 

[rednesss]

The 2 screws can be removed without having to disassemble the interior pieces along the quarter glass. What I did, was cut a phillips head drive bit down and then put that in the closed end of a 1/4" wrench to remove the screws. Just don't drop the screws into the bottom of the quarter well.

 

[AHcuda]

Thanks !!!