glhx
Well-Known Member
They are too long......I’m closing them down to square
Last edited:
Still can. Proto® Ignition Point File - Proto IndustrialYep... that will at least get that part in the right spec. If you get the chance, measure the maximum gap of the points before you adjust them... just for info.
Also, look at the gap and make sure there are no little metal tits on either side. If so, a VERY fine file is used to smooth them.... you used to be able to buy 'points files' for just such a purpose.
The dwell was tested with a swell meter and showed 42 as opposed to the 32 you showed.
Will test drive it soon and see if that stumble is gone.
If I readjust the points.
Will I need to retime the engine?