smartken22
U.S. Navy Senior Chief
Contact seller
My 340 is currently at the engine builder and he is just about finished with the build. We are making preparations to run it on his engine dyno and I am in need of a header flange in order for him to get EGT readings. He wanted to drill a little hole in my headers, but they are brand new Dougs and they are ceramic coated so I have a hard time with that one. He said if I got a flange, he could put a hole in it and install the probe there. He stated that the probe needed to be 1 inch from the heads. Not sure if anyone has done a similar setup on the dyno or not. Any help would be greatly appreciated.