64 Barracuda, grill center broken, hlep

[Fstforward]

In the following pics, I have shown a problem I have. The center section of the 64 grill is broken on one side. The material appears to be a pot metal. What would be the best way to fix this?? I have a pic of the good side, and of me holding the broken part near where it goes.

Thanks

FF

 

[grimreaper]

I would use Muggy Weld to fix it. I have a grille fixed with Muggy Weld and you could never tell it has been repaired. It's strong too. It was broke just like yours is.
http://www.muggyweld.com/potmetal.html

Good luck with your repair.

 

[Fstforward]

Wow. Just watched a couple fo the videos on the link you supplied, cool stuff. And with a propane torch.

Thanks that will help out immensely

FF

 

[grimreaper]

One of the few products that actually works like the sales videos show. Just make sure you have both parts clean, clean, clean. Rig up a little holding fixture with two alligator clips on the ends of a short length of coat hanger wire, bend as necessary to hold the piece in correct alignment, heat, flux, add rod and be amazed.