68 Barracuda license lite jumper wire.

[68 CUDA FORMULA S]

Does anyone have or can post a picture of what the factory 1968 Barracuda rear bumper license lite jumper wire looks like. The FSM shows that it runs from the drivers side tail lite over to the license lite, but does not show the wire itself. My tail lite has two bare connectors on the wires, I am guessing that is where the jumper wire connects to. Has anyone ever seen a company that repops them, I can make my own but I would like to see what the factory original looks like. FOUND!!!
Thanks
Bob

 

[69FBCuda]

69 Barracuda

 

[jawbone]

How far? It does go to drivers side of car. Termination unknown.

 

[68 CUDA FORMULA S]

I am going to have to look at my rear harness a little better, I did not see it in there. I hope I just overlooked it, may have been cut off and I missed it. Thanks for the pictures

 

[68 CUDA FORMULA S]

Thanks guys, it was such a clean cut that I never noticed or felt it there. Now I just need to splice a new end on it along with a grommet and I will be good to go.
Thanks again
Bob