Another stupid motor mount question

[coffeedart67]

I feel completely stupid asking this, but it has been too long since I took the motor mounts off of my 273 and I don't remember how they go back together. The question I have is does the bolt on the rubber mount go in the upper hole or the lower hole. Looked at the service manual cd I have but the pictures are worthless. Any recomendations on where a person can find an original hard print service manual (67 Dart)?
Thanks
Aaron

 

[67Dart273]

The 67 manual I have (Dodge) shows nothing for A body mounts. The 69 manual does, but ti's about worthless. The brackets go to the rear of the engine casting ears, and the mount pad has a small "bump" on one side next to the bolt. With the stud on the pillow down, the bump up, this bump aligns with the top hole in the engine brackets

 

[crackedback]

Another deal. Make sure you install brackets on with the biscuit mount holes towards the front on each side.

 

[Romeo]

What application would have engine mounts that would allow me to lower the center line of my engine. Not worried about rad alignment.