Anybody using Dynacorn Duster wheel well mouldings?

[KnuckleDuster]

How do you like them?

Who did you get them from?

How do they stack up vs good used or NO$?

Any better repro's put there?

I'm a little iffy about them being made in Taiwan,but if they look good...what isn't these days?


Semi-related- Anyone know a supplier for the rocker trim clips?

 

[moparmat2000]

i know the rear outer wheelhouses on the duster are the same as the 67 thru 69 barracuda, i wonder will a full set of these fit my 67 cuda?

 

[KnuckleDuster]

Bump

 

[twister360]

How do you like them?

Who did you get them from?

How do they stack up vs good used or NO$?

Any better repro's put there?

I'm a little iffy about them being made in Taiwan,but if they look good...what isn't these days?


Semi-related- Anyone know a supplier for the rocker trim clips?

I installed a full set on my 74 Duster and I am really pleased. At first they don't seem to fit, so I installed the first screw in the center of the moulding and worked my way to the ends. You may have to sort of message them to get the next screw installed, but once in place they certainly look good.

Absolutely better than used, Stephens wanted $199 each for used and NOS would be expensive as well. I got mine from a guy in Florida.

Gary

 

[RJS]

I bought a set for my Demon on Ebay and they were like $30 or so per molding,
Aside from the screw holes being oval instead of round they jumped on and look good.
Ron