I saw a 67 Barracuda dash in a 67 Dart. I always liked the round gauges the Barracudas have. It's obvious the dashes are the same size but are there any differences in the way they mount. Anything to watch for should I decide to do the swap?
Most likely I will need the barracuda dash harness. I know the frames are different where the gauges mount. Wonder if the lower mounts are the same?You may need the dash harness, as you probably know the metal dash frames are different.
Alan
I can almost guarantee that all the mounts will be the same.Most likely I will need the barracuda dash harness. I know the frames are different where the gauge amount. Wonder if the lower mounts are the same?
I think if I go forward with this, I will get a complete dash with everything in it. That way I will have all bases covered.
I did forget about that. Thanks for the reminder.Been there, done that. Dash frame, all gauges, all wiring must be interchanged. Don't forget, in 1970 they went to the ralley instruments. Wiring for the tail lights and engine remain the same.