Do you have the fork, boot, pivot, and cover? You will need to find out what exactly it fits.
Do you have the motor plate?
Actually there is a part number stamped inside the bellhousing and then they paint over it. But if you look you should see it. They no longer make this bellhousing. Don't give it away. You're looking at $400 for that part without the block plate.
Just my humble opinion which I always consider.
Just your humble opinion, but your not sending him $400 dollars. Right?Actually there is a part number stamped inside the bellhousing and then they paint over it. But if you look you should see it. They no longer make this bellhousing. Don't give it away. You're looking at $400 for that part without the block plate.
Just my humble opinion which I always consider.
.i didnt know this until recently. there is a serial number stamped on the flange somewhere. i was told by lakewood they werent going to recertify any more bell housings without the serial number. i learned that last fall when i sent a bb bell in for recerttification. it had a serial number so they did that one.
That looks just like the dual pattern SB lakewood bell my bro ran in his 64/340 Barracuda. Used a hydro T/O bearing. Those flanges on the bottom stick out a little when looking under it
.
What did it cost you to get it recertified?
Here is the one I paid $325 for. You don't see it but the block plate is there also.
View attachment 1715928110
.The OP's one does not have a block off plate. Big Difference. Where are you going to get JUST the block off plate?
.
I bought a new block plate at the Mopar Nationals several years ago. I still have it as a backup.
.Are they available new?
I only see mopar big block:
Manual Transmission Bellhousing Safety Plates - Free Shipping on Orders Over $99 at Summit Racing
dang, my bro lost his Gen 1 w/Lakewood bell in a storage lock out in Anaheim, CA. He was stationed up in WA in the Navy and called me to tell me to grab everything you could before midnight of that night. I had about 5 hours to stuff a breakdown picker into the back of my Breeze and run out to his storage and start pulling his 340 alone. I got it and some carbs but the 833 would not come out.I think you are correct . Guy I got it from said it was on a gen 1 Barracuda.