cam shaft..

[grassy]

I am selling a "stock" 360 cam shaft. That is all I know about it. the PO bought a different cam and swapped out the "stock" one.

How can I tell what this cam is...the engine was a quasi crate...the PO bought it as a rebuilt motor..

Thanks
Ian.

 

[krazykuda]

For a ballpark, measure the base circle and then the lobe with a set of calipers or micrometers. Then subtract the difference and multiply by 1.5. Do for both intake and exhaust lobe.

That should give you a close estimate on what lift it has, then try to match it from there.

 

[OldmanRick]

As Karl said Ian ^^^^^. Best way to get you close.

Any number at all on either end?

 

[grassy]

Rick, no number on ether end so I shall measure it.

Thanks
ian.