cuda windshield moulding

[0ld school]

i need only the pass side pilar stainless. it needs to not have any bends or dings. its for a 1968 cuda. thanks

 

[Moparparts]

I have that PM me

 

[0ld school]

still looking for this....

 

[MOBodyman]

I'm pretty sure I have it but it will be Sunday before I have a chance to look.
Dallas

 

[Rocky_JS]

this molding is "very" common and even repopped. Including all 23 series darts up to the mid 70's, as well as 68-9 barracuda's.

 

[0ld school]

still looking, can anybody help with this? I would prefer oem......

 

[MOBodyman]

still looking, can anybody help with this? I would prefer oem......

I think I forgot to look for this. I made a note and will try to be sure to look tomorrow (if I don't forget the note! LOL)
Dallas

 

[CAMOPARS]

still looking, can anybody help with this? I would prefer oem......

I am 99.9% sure I have a few in storage in case you cannot locate one. Let me know.

 

[RedFish]

You can use the same piece from any 4 door A-body. You'll need to trim exactly 1.5 inches from its length and recreate the small notch, 10 minutes with a hacksaw or grinder and file.

 

[CAMOPARS]

You can use the same piece from any 4 door A-body. You'll need to trim exactly 1.5 inches from its length and recreate the small notch, 10 minutes with a hacksaw or grinder and file.

I should have one for a 4-dr as well if you want to go this route.

 

[Oklacarcollecto]

still looking, can anybody help with this? I would prefer oem......

It can be found on a bunch of A-bodies on different years so don't just keep centered on a 1968 Barracuda. It will be OEM because they continued using the same identical part.

 

[MOBodyman]

I think I forgot to look for this. I made a note and will try to be sure to look tomorrow (if I don't forget the note! LOL)
Dallas

I remembered my note this time. I do have a nice one. I'll send you a pm.
Dallas