swing69
fightin' socialism
For our project 65 Barracuda, I was looking for a lower fender patch, for behind the front wheels. I scored one here, at it looked to be the same, but I knew it was from a Dart.
We cut the old piece off, and squared up the donor part; Low and behold, the dart fender patch was ~ 1/2" narrower than the removed barracuda
section.
Not a big deal at all. we split the donor part and added a 1/2 filler. Piece of cake. Tabs added to make it easier for the kids to weld. Picts to follow. off today due to Pres. day.
BTW:
I'm aware the the profile may not be EXACT...but damn its very very close,
Also: I'm aware about eventual rust in the backer strips. But heck, I'll be long gone before thats really an issue on this thing! lol
We cut the old piece off, and squared up the donor part; Low and behold, the dart fender patch was ~ 1/2" narrower than the removed barracuda
section.
Not a big deal at all. we split the donor part and added a 1/2 filler. Piece of cake. Tabs added to make it easier for the kids to weld. Picts to follow. off today due to Pres. day.
BTW:
I'm aware the the profile may not be EXACT...but damn its very very close,
Also: I'm aware about eventual rust in the backer strips. But heck, I'll be long gone before thats really an issue on this thing! lol