Dartswinger70
Well-Known Member
I have some loos pins in both printed circuit boards of my rally dash. Does anyone repop these PC boards? Also, the 194 bulb sockets, are they available?
Dash Printed circuit board Rally Dash
- Thread starter Dartswinger70
- Start date
-
You can repair the boards by soldering them on the pin side. It is not hard. Take your time and work slow.
Also use the search engine, and you can find some good threads on this subject. I have repaired 3 boards myself.
Dave
Also use the search engine, and you can find some good threads on this subject. I have repaired 3 boards myself.
Dave
The pins are available and I have the tools to properly swage them in place. There was a thread recently I posted pics in.
Here is a thread on it at moparts.
Repairing cluster circuit board... feasible? | Moparts Question and Answer | Moparts Forums
Repairing cluster circuit board... feasible? | Moparts Question and Answer | Moparts Forums
Dartswinger70
Well-Known Member
I did get the PC boards repaired, i soldered the three loose pins for an electrical connection and used glue on the back to keep them from moving. I dont know if this will last long term though. I did like the idea of new PC boards, pricey, but isn't everything Mopar? Thanks for the replies on this.
-
