[WANTED] Drive shaft for a 66 Barracuda/Valiant

[Takoctopus]

I’m looking for a driveshaft for a 66 Barracuda or Valiant. I need one I can cut down to fit a 8 3/4 rear. If the shaft is near Indiana I would come and pick it up. If some one has just the yoke that slips in the transmission I would consider that also. The transmission in my car is a A903. If some body is parting a car out near Indiana I am looking for some brake parts also.
Thanks in advance

 

[65 Dartman]

If your transmission was a 65/earlier with the B & T flange, I have a conversion driveshaft that would bolt right in. Don’t think this one is gonna work!

 

[Capt46]

Pmd

 

[mycuda]

If you mean 904 trans might have yoke and a shaft that could work.
Ill PM you later today.

Dave

 

[Takoctopus]

My transmission is the A903 three on tree. It’s a little strange but I think any drive shaft from a 66 and newer with a three on a tree would work. I will look around for a picture of what the shaft should look like. Thanks again

 

[mycuda]

My transmission is the A903 three on tree. It’s a little strange but I think any drive shaft from a 66 and newer with a three on a tree would work. I will look around for a picture of what the shaft should look like. Thanks again

Gotcha.
Have 30 spline trans yoke and should have long enough driveshaft, check later.

Dave