For Sale: 1962 Dodge Lancer GT

-
Status
Not open for further replies.

boosted

Life Needs Air
Joined
Oct 26, 2008
Messages
1,414
Reaction score
397
Location
Muscogee/Harris County GA
Rating - 0%
0   0   0
Contact seller
Great little 2 door lancer. Has a /6 push-button 2 door. Have reciepts where the motor had been replaced, head done and all. Good running little car that is very original.. Bucket seat, radio delete car..

I hate to sell it but it just sits as I never get it out and drive it anymore..

Price to sell at $2200

Hard to find them like this anymore... Car is located in Midland GA...
 

Attachments

  • 61012 008 (Large).jpg
    76.2 KB · Views: 2,179
  • 5U15F65H63Le3Md3I3c25c86a5bbc12e110cd.jpg
    19.4 KB · Views: 1,587
  • 5X25Mf5Jd3G13Jb3pcc3p09661e1980eb1756.jpg
    75.1 KB · Views: 1,893
New pics...
 

Attachments

  • 61712 009 (Large).jpg
    103 KB · Views: 1,560
  • 61712 011 (Large).jpg
    81.4 KB · Views: 1,497
  • 61712 008 (Large).jpg
    101.2 KB · Views: 1,523
  • 61712 007 (Large).jpg
    77.7 KB · Views: 1,489
  • 61712 006 (Large).jpg
    105.8 KB · Views: 1,500
  • 61712 005 (Large).jpg
    69 KB · Views: 1,548
  • 61712 004 (Large).jpg
    80.8 KB · Views: 1,504
  • 61712 003 (Large).jpg
    84.9 KB · Views: 1,520
  • 61712 002 (Large).jpg
    86.5 KB · Views: 1,504
  • 61712 001 (Large).jpg
    64.7 KB · Views: 1,541
Can't tell which of the three available \6 engines it has. How 'bout an engine shot looking in from the driver's side so we can see the manifold side of the block?
 
Here you go.. I took a few as I did not know what you were looking for..
 

Attachments

  • 62312 013 (Large).jpg
    76.3 KB · Views: 1,354
  • 62312 014 (Large).jpg
    113.5 KB · Views: 1,335
  • 62312 015 (Large).jpg
    93.7 KB · Views: 1,370
That's a '67-'75 RG engine block, so this is almost certainly a 225 but there's an outside, slim chance it's a '70-'74 198. Red paint means either someone took the trouble to spray a '69-up engine or this is in fact a '67-'68 225 engine with its original red paint. If this is a '68 or later engine, you hope whoever swapped the engine used the needed but little-known adaptor bushing between the (small) torque converter nose and the (large) crankshaft counterbore.
 
/6dan is there any way of telling this without pulling it out? Car runs and drives real good with no off noise of anykind. Transmission shifts good also....
 
No way to tell without pulling the engine. If a '68-up crank is put in front of a '67-down trans, there usually won't be any shifting irregularities or noises, but the trans front pump bearing and seal won't last.
 
I'll swap you a couple of guns for it.
 
It is going to be redone.. I picked up a good front bumper for it yesterday and a good fuel tank.. I got to smelling fuel and evidently the PO decided to bondo a place on the tank which did start leaking again.. So now it has a good fuel tank to stop that.. After this it is time for paint and body.. And I have an uphostery guy waiting for the two front seats..


Wont be long now.. What kind of guns are you talking on trade? PM me....
 
Status
Not open for further replies.
-
Back
Top