Frame Splash Shields

[old65-4spd]

I need pics of the frame splash shields in their location on 65 Barracuda for both the 2 metal ones and the 2 rubber rectangular ones. I think I know where the LS metal one goes, but there are no holes as the original frame rails were replaced some years ago in the early stage of restoration. I’m now finally in the assembly phase and it’s too long to remember. So before I drill any holes, I need confirmation of the exact position. Any help is greatly appreciated.

 

[69FBCuda]

Left lower

Left front behind the headlight, see it on the left side above the bumper bracket

 

[old65-4spd]

Okay, so the first pic shows LS metal shield where I suspected and I will need to drill 2 holes. So the other metal shield would likely go to same position on the RS.

I’m not sure what you are showing in the second pic. I see two holes below the bumper bracket. Could these be for the rectangular rubber shields, one each side?

Thanks for the reply and pics!

 

[dadsbee]

pic shows LS metal shield where I suspected and I will need to drill 2 holes.

Holes should already be in the frame rails...

 

[dibbons]

Holes should already be in the frame rails...

In the first post he stated the factory frame rails were replaced, so he was at a loss as to location.