I bought a used heater box for a 72. All went back tighter well except one screw between the heater tubes. It was stripped and will not tighten. There is a grounding wire connected to this screw.
My question is what can I use to repair the hole enough to get the screw to hold the wire terminal?
I thought about fiberglass or JB weld. Can I coat the screw so it does not get fixed into the hole? Need to get it snug to hold the ground.
My question is what can I use to repair the hole enough to get the screw to hold the wire terminal?
I thought about fiberglass or JB weld. Can I coat the screw so it does not get fixed into the hole? Need to get it snug to hold the ground.