Help identifying this harness

[DusterDaddy]

My Duster was a basket case when I bought it. I did not remove this short harness when I disassembled the car, but to when sifting through boxes and bins that were in the trunk I came across this harness. can anyone tell me what it's for?
Thanks

 

[krazykuda]

That's for the engine compartment.

The bottom round one goes on the hot wire of the alternator with a nut, the other two are field wires, then the pruple one with the 90° elbow fitting goes on the temp sensor mounted in the intake on the pass side near the thermostat...

then in the last picture I see an electronic distributor connector.

I'm not sure about the rest, but you should be able to trace them with a service manual in the wiring diagrams in the back of chapter 8.

 

[krazykuda]

1. Goes on back stud of alternator with a nut.

2. Goes on field terminals for alternator.

3. Goes on temp sensor mounted on intake near thermostat on pass side.

View attachment Wire 1b.jpg

View attachment Wire 2b.jpg

This last one goes to electronic distributor.

View attachment Wire 3 b.jpg

 

[DusterDaddy]

1. Goes on back stud of alternator with a nut.

2. Goes on field terminals for alternator.

3. Goes on temp sensor mounted on intake near thermostat on pass side.

View attachment 1714828647

View attachment 1714828648

This last one goes to electronic distributor.

View attachment 1714828649

This must be a spare because nothing on the other engine compartment harnesses i took out when disassembling the car is cut

Anyone know where the two cut connectors go to?

 

[whitepunkonnitro]

That style of harness (two piece engine) is universal to all 73 up cars.