[SOLD] Holley Ultra 770 Street Avenger W/Dual Feed Line, Gauge, and 2" Spacer

-
Status
Not open for further replies.

smartken22

U.S. Navy Senior Chief
Joined
Feb 20, 2011
Messages
887
Reaction score
75
Location
Lemoore, California
Rating - 100%
10   0   0
Contact seller
This is a nearly new Holley Ultra 770 Street Avenger carb off a built 340. I am in the process of installing the Holley Terminator EFI so I am no longer in need of this setup. Carb has been professionally tuned by Competition Carburetion out of Nevada. Carb comes with all extra vacuum springs, floats, original 73 jets and 31 squirter. Specs are listed below:

- Jets: 71 Primary / 80 Secondary
- Vacuum Secondaries
- 6.5 power valve on primary side
- 37 squirter
- Accel pump has a orange cam
- Electric Choke
- Steel braided -8an inlet dual feed line with -6an exit.
- Fuel pressure gauge
- 2" plastic spacer

Item is located in Central Cali. I am asking $550 shipped obo. Thank you and let me know if you have any questions or concerns.
 

Attachments

  • IMG_3338.jpg
    49.8 KB · Views: 744
  • IMG_3339.jpg
    49.7 KB · Views: 727
  • IMG_0105.jpg
    52.7 KB · Views: 725
  • IMG_3375.jpg
    36.2 KB · Views: 742
  • IMG_3383.jpg
    26.5 KB · Views: 712
Spacer has been tossed. I just noticed that it was warped so it is no longer included. Carb still available. Reduced $500 obo.
 
Hmm I'm tempted. How did it run on your 340? I too have a built 340 with aluminum heads and all that with a 670 street avenger and I've always wondered if I should go with a bigger carb.
 
Once I had it tuned for my engine setup, it ran great. I had a lot of issues at first with A/F ratios and jetting because I am running a hot cam (See build link in sig). My engine builder sent it out to his carb builder, had it tuned and I had no issues since. Found a really good deal on the EFI which is the only reason it is getting sold.

Hmm I'm tempted. How did it run on your 340? I too have a built 340 with aluminum heads and all that with a 670 street avenger and I've always wondered if I should go with a bigger carb.
 
Does this have the stock Holley body on it or something else?
 
Here are some updated pics as promised.
 

Attachments

  • IMG_1992.jpg
    24.4 KB · Views: 230
  • IMG_1991.jpg
    47 KB · Views: 222
  • IMG_1990.jpg
    32.4 KB · Views: 244
  • IMG_1989.jpg
    30.9 KB · Views: 222
  • IMG_1986.jpg
    23.9 KB · Views: 217
  • IMG_1985.jpg
    33.5 KB · Views: 223
  • IMG_1984.jpg
    29.6 KB · Views: 210
  • IMG_1983.jpg
    31.9 KB · Views: 250
  • IMG_1982.jpg
    35 KB · Views: 232
  • IMG_1999.jpg
    27 KB · Views: 223
Status
Not open for further replies.
-
Back
Top