I need to find a bucket seat hinge bolt.

-
rednesss

rednesss

Well-Known Member
Joined
Mar 4, 2006
Messages
1,423
Reaction score
219
Location
Eugene, OR
I seem to be missing one of the bolts that go through the hinge and holds the upper part of the bucket seat onto the bottom. Does anyone have one or know where a guy could buy one??? These are out of 68 Barracuda and are the low back buckets. Thanks.
 
Yes I do. See attached.

Photo0073.jpg
 
Could you give me some dimensions of the bolt you need. Length, shank length & diameter, and thread diameter. I am not very familiar w/ 68's, but I have buckets of bolts I can dig thru.
 
The one I had looked different I will take it off tomorrow and see if by chance it is the same
 
Well it's 3/8" coarse thread, overall length is about 1 3/4", the shoulder at the top is about 5/8" in diameter, the threads part are only about 7/8" long and the shoulder part is about 5/8" long and it takes a 3/4" socket.
 
I found 2 different ones that are close to yours. Send me a PM w/ your address.
 
Did you get the seat bolt and does it work for you? :read2:
 
I did get it, thank you again. I haven't had time yet to work on it unfortunately. Maybe this weekend if I'm lucky.
 
You must log in or register to reply here.
-

Back
Top