Intake ????????

[jamesg63]

I have a 360 with EGR heads out of a 73/74 Dodge Motor home. It is an original 2 barrel engine. I have an Edelbrock Air Gap Intake 4 Barrel Intake I want to use on it. Only problem I see, (may not even be an issue) is the intake does not have the center ports like the heads? Any input is welcome!

 

[70aarcuda]

the "center ports" are heat cross over...the air gap intake will block them off...

they provides heat for intake manifold during cold weather......

 

[fishy68]

It'll work fine. Just a little more cold natured

 

[Abodybomber]

This will take time,in the mornings in I'll. if a driver. That part,you didn't post.....

 

[jamesg63]

Should I silicone around those ports? Yes it will be a daily driver.

 

[70aarcuda]

no silicone is needed...the gasket and intake will cover them...