Looking for help with paint prep

[Stlrfreak]

So have front end off my demon for new bushing kit . Parts that came off being sandblasted . my problem is getting area behind control arms ready for some primer and paint . darn grease is like baked on and contours make hard to scrape,and cant use power washer in garage. Any suggestions on how to get it cleaned enough to prime and paint

 

[Old Tired Rebel]

heat gun and scraper then use a heavy degreaser afterwards

 

[dustermaniac]

Brakecleen

 

[Stlrfreak]

heat gun and scraper then use a heavy degreaser afterwards

but need to wash degreaser off old garage wont take water kindly

 

[Stlrfreak]

Brakecleen

have some will try tomorrow ,

 

[Stlrfreak]

Anyone hear anything about siphon feed sand blaster from walmart

 

[waggin]

Brakecleaner's gonna be very expensive, I use a propane torch and a scraper, wear gloves and safety glasses, lotsa work to do all that....

Brakecleen

 

[George R]

Use a wirebrush to get the caked stuff off, then wipe it down with lacquer thinner or something.

 

[Abodybomber]

Try oven cleaner,with the parts preheated by sunshine.

 

[swapdaddyxx1]

Anyone hear anything about siphon feed sand blaster from walmart

I have never seen a siphon fedd blaster that was worth messing with. If you are going to sand blast, a pressure pot is the only way to go. You will need lots of cfm from your compressor tho.
The oven cleaner would be worth trying, I have used it for different projects in the past and it worked well.