It’s a trim piece I’m working on with @Dana67Dart. It’s just to dress up the opening in the insulation that was cut to allow fresh air from the scoops
Sorted out a weird issue with the blower motor. I had all 3 fan speeds with the air conditioning on but with the heat on, I only had low fan speed. I took the glove box out to diagnose, and this is what I found.
View attachment 1716205946
I really like the simple fixes! I must’ve bumped it when I was installing the dash and knocked the connector off.
I got the drivers door glass put in, but I’m struggling with the adjustment to get a good seal. Took a pause from that for my sanity decided to apply my stripe.
View attachment 1716205947
View attachment 1716205948
I ordered the film I wanted from an online vendor then shipped it to @challengergary. For a fee, he cut it and applied transfer paper for me.I've always wanted a bumble-bee stripe to match my vinyl top. Where did you get those?
The red against the stripe has always been my only concern.
thank you so much!The attention to detail is impressive. The history with the Dart is a lot of fun to read. Your paint certainly pops!
Very nice! What was the timeline your painter gave you?The paint and Dart are so much nicer than factory. Who would ever guess the love and attention we give these cars. The 64 Corvette is detailed 10x’s the level of a production car. Inside the engine compartment fender wells, under the hood, etc is as nice as the exterior. On an original it was a shade of black. When I took my Dart by my painter today, I mentioned all I really wanted was a driver and had not expected to go this far with the car. Both of them said it’s not in your nature and laughed.
View attachment 1716241258
View attachment 1716241259
View attachment 1716241260