Need Zbar to frame rail bracket

[charliec]

My 68 Dart 340 SB was apparently converted to 4spd at some point, and not so well done! There was no bracket used on the frame rail end of the Zbar...just poked a hole throught the sheet metal . Predictable result:

So, now I'm looking for the correct frame rail bracket for this end of the Zbar. Or, should I just used some heavy plate and fab one myself? Where can I find the correct bracket?
I assume that the location and alignment of the hole is pretty critical to clutch pedal operation. What is the best way to set it in the correct place? Should I cut away that old sheet metal and weld directly to the frame rail?

 

[Fast340cuda]

I found my last bracket on eBay but pretty sure brewers will have what you need.

 

[Alaskan_TA]

Brewers has them new - Brewer's Performance - Mopar A833 4-Speed Transmission and Component Specialists

 

[Princess Valiant]

Mopar Z Bar Torque Tube Frame Bracket Clutch 67-76 A Body Duster Demon Dart | eBay

 

[moparmarks]

I'd just weld up that crack and then weld the bracket over it.

 

[Kendog 170]

The hole location should be correct. I believe it is there from factory just no bracket if auto trans. car.

 

[moparmarks]

The hole location should be correct. I believe it is there from factory just no bracket if auto trans. car.

Yep. I changed my 72 to a 4-spd and the hole was drill at the factory and had a plug in it. Just had to weld the bracket on it.

 

[GREEN DART 5]

I’ve got one. It’s used but still in useable condition. PM me your address and I’ll drop it in the mail for you.