Picture Time Stroker getting close to startup

[northeastmopar]

Thought I would share these. Finally got the front end married to the motor. Waiting for bolts to install the tranny and we will be ready to slide her under. Need to get the TTI headers. Also have to get a 4" tall K & N filter to replace the 2" tall one shown. Need more filtration for the 750. Aluminum radiator and overflow can. Looking to do braided radiator and heater hoses. Also needs to get the A/C compressor fit up. Getting one from aftermarket. Still looking for hoses for the brake calipers which were reversed because of the stock sway bar.

 

[pettybludart]

Looking good.What size stroker?Can you tell us abit about the build.Thanks

 

[northeastmopar]

Looking good.What size stroker?Can you tell us abit about the build.Thanks

Just wanted to build a nice street cruiser. Scat 4" crank with Scat Ibeam rods and Icon forged dished pistons. Lunati voodoo 60404 flat cam with roller rockers and the Edelbrock closed chamber heads. Bored 30 over the 340 will become a 416. Tranny has a B&M TransPak and I had the torque converter built with about a 2500RPM stall. Carb is a 750 sitting on the special Nascar Edition Performer Air Gap. Double roller chain and high volume water pump. I intend on installing a Griffin aluminum radiator. Compression ratio should be about 9.6:1. I have no clue what the HP or torque will be. Anybody want to guess?