is it in the end of the crankshaft I didn't change itChange your pilot bushing?
but thought it would be about a inch if it wasn't going inis it in the end of the crankshaft I didn't change it
different transis this a new or different trans or has it been in before
engine 69 340 transmission a 66 or 67different trans
Sorry just read the other comments these guys are right check the hole in the bellhousing.The crank may not be drilled deep enough for the input shaft. Was the engine an automatic before this?
will do thanksSorry just read the other comments these guys are right check the hole in the bellhousing.
You can machine the O.D. of the retainer or find a smaller one. Good luck.bearing retainer is the wrong size