dgc333
Well-Known Member
Brown just dropped off a nice new Cross Wind manifold for my 360 today.
The casting and machining look good, don't have a gasket to check the port alignement. Don't really know how it compares to a Edelbrock RPM Air Gap but they are going for $140 on Ebay right now comapred to $270 for the magnum version of the Air-Gap. I couldn't resist.
Anyone interested in a Weiand Excelerator single plane for a small block? I believe Weiand advertises the operating range for this single plabe to be 1800-6500 or something along those lines. I was going to use it but when the opportunity came up to pick up a set of magnum heads the Cross Wind seemed to be less hassles than trying to get the Excelerator to fit.
Make me an offer if you are interested.
The casting and machining look good, don't have a gasket to check the port alignement. Don't really know how it compares to a Edelbrock RPM Air Gap but they are going for $140 on Ebay right now comapred to $270 for the magnum version of the Air-Gap. I couldn't resist.
Anyone interested in a Weiand Excelerator single plane for a small block? I believe Weiand advertises the operating range for this single plabe to be 1800-6500 or something along those lines. I was going to use it but when the opportunity came up to pick up a set of magnum heads the Cross Wind seemed to be less hassles than trying to get the Excelerator to fit.
Make me an offer if you are interested.