rearend and driveshaft u joints

[67barracuda]

I just put in a complete rear pig and found it to have the large yoke, but my drive shaft has the the small yoke. I could pull the small one off the old rearend and put it in, but I just got this rearend set up. I there a u joint that allows you to mate a small with a large yoke together?

 

[green67cuda]

yes...you gan use any combination of 7260, 7290, 1310, 1330, AND 1350

just gotta know exactly which 2 sizes you need to mate

( a guy at work thought i had a big joint on mine, but i knew it was a 1330, so i got a 7260-1330 joint....and then changed the driveshaft anyway...........to a 1350)

 

[67barracuda]

Thanks, what do I need to do the tell which one I have? Do I just measure the width?

 

[73Scamp]

look down a few posts at the subject line u-joints

 

[scamp73]

i just got this u-joint yesturday from napa. its a 347. There part number. its a big at one end and a small at the other. $30

steve