Creedmoor
Recovering Fordaholic
Was going through the instructions in my just arrived TF-2 shift kit and there was this supplemental page, not part of the original stapled 7 pages which addressed "servo-flop". I have three questions about this mod:
Is this a real issue?
The TF-2 kit is meant for either a 904 or 727 but the instructions for this mod only mention 727's. I know the rear servo is pretty much the same between the two. So, since I'm putting it in a 904, should I make this mod?
Has anyone done this for a 904 - any tips, best methods?
Is this a real issue?
The TF-2 kit is meant for either a 904 or 727 but the instructions for this mod only mention 727's. I know the rear servo is pretty much the same between the two. So, since I'm putting it in a 904, should I make this mod?
Has anyone done this for a 904 - any tips, best methods?